Page 1 of 1
CR/kdx Hybrid Question
Posted: 10:50 pm Jun 21 2008
by SVandal
For those who have done this hybrid, do you need to remove any engine components to fit the motor into the frame? If so, how does the effect re-assembly? I asked over at DR, but wanted to see if anyone here had experience with it.
Thanks
Posted: 09:40 am Jun 24 2008
by KarlP
I had to leave the head off my KDX motor to get the motor into a '99 CR250 frame.
The carb was a tight squeeze also, but went leftrightupdowntwistleftIN
Posted: 02:47 pm Jun 24 2008
by SVandal
I managed to get mine in using about that same method, though the head was left on. Now I am going to see if I can fit a pipe. The 2003 is pretty tight unless I find a way to make some extra room between the frame down tube and the head. Thanks for the help Karl!